Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Plot z=(x,y) in COMSOL

Posted 2017年9月3日 GMT-4 13:56 Results & Visualization Version 4.3b 1 Reply

NDN UNIST/Mechanical Engineering
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear all

Does anyone know how to make a plot z=(x,y) in comsol ?

I need to make this plot to evaluate my design
Best regards
1 Reply Last Post 2017年9月5日 GMT-4 07:47
Mark Harradine
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 2017年9月5日 GMT-4 07:47
You can add a Height Expression to a standard surface plot in your results, (make sure mesh and cut-plane resolution are sufficient for your needs). See attached example. I am not sure if the Height Expression capability is available in version 4.3...

An analytical surface plot can be created if that is what you need (see attached).

Hope this helps,

Mark
You can add a Height Expression to a standard surface plot in your results, (make sure mesh and cut-plane resolution are sufficient for your needs). See attached example. I am not sure if the Height Expression capability is available in version 4.3... An analytical surface plot can be created if that is what you need (see attached). Hope this helps, Mark

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content