NaN for a paramter study using probes

Please login with a confirmed email address before reporting spam

The below post is related to an archived discussion


Hi,

I am getting the same error as posted above. Has anyone found a solution?

The issue: I want to do a parameter sweep and using probes I want to populate a table. One way to do so is populate the table with the probe values as I sweep. However, I am running COMSOL on a cluster where it just solves and I need to post process the data to make the table. The issue is for a certain probe, I get NaN values for all the sweep points except the last one.

Best, Hitesh


1 Reply Last Post 2020年1月16日 GMT-5 下午10:14

Please login with a confirmed email address before reporting spam

Posted: 3 months ago 2020年1月16日 GMT-5 下午10:14

Hi, Which probe are you using? I have used cut pint 3D to plot data into Origin lab. At that time software return NaN error (Not a number). After looking for many information for many days, I just realized that my unit is wrong so the dot it out of the geometry.

Hi, Which probe are you using? I have used cut pint 3D to plot data into Origin lab. At that time software return NaN error (Not a number). After looking for many information for many days, I just realized that my unit is wrong so the dot it out of the geometry.

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.