Adding electrical circuit in a Laminated busbar model

Please login with a confirmed email address before reporting spam

Hi,

I'm modelling a basic planar busbar with an insulation layer in between the positive and negative layers. I need to add an electric circuit to this model. The circuit consists of a dc voltage source, connected across a resistor. Here instead of the wires connecting the source and the resistor, I need to use the positive and negative layers of the laminated busbar.

I have added a screenshot of the model for reference. In that, P1, P2 are the terminals of the positive layer and N1, N2 represents terminals of the negative layer. The dc source is connected across P1, N1 and resistor across P2, N2. I have also included a small basic figure of the circuit that I'm trying to build, within the screenshot.

I know I need to use 'External I vs U' in the Electric Circuit section, but I'm not sure how to do this. Can anyone help?

Regards Aravind



0 Replies Last Post 2020年4月5日 GMT-4 上午4:02
COMSOL Moderator

Hello Aravind Venugopal

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.