Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

2D plot from a parametric sweep in 1D geometry

Please login with a confirmed email address before reporting spam

Hello I've performed a parametric sweep in 1D geometry and would like to plot some of the results as function of both the x coordinate and the parameter I'm changing. When I add a 2D plot group I can't choose any dataset to plot with. When I add 1D groups I can, so I suspect it's because the model geometry is lower than 2D... Any ideas how I could do this?

Thanks Eyal


2 Replies Last Post 2020年7月30日 GMT-4 11:38
Gunnar Andersson COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2020年7月30日 GMT-4 06:30

You can use a Parametric Extrusion 1D dataset: It extrudes the 1D geometry into a 2D geometry where the x-coordinate is the x-coordinate in the 1D geometry and the y-coordinate is the parameter that you've swept over.

You can use a Parametric Extrusion 1D dataset: It extrudes the 1D geometry into a 2D geometry where the x-coordinate is the x-coordinate in the 1D geometry and the y-coordinate is the parameter that you've swept over.

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2020年7月30日 GMT-4 11:38

Thank you, that's just what I needed.

Thank you, that's just what I needed.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.