Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Modeling Crack Growth in geothermal Reservoir
Posted 2024年6月3日 GMT-4 10:44 Modeling Tools & Definitions, Results & Visualization, Physics Interfaces 0 Replies
Please login with a confirmed email address before reporting spam
I'm currently attempting to model crack growth resulting from an increase in pore pressure due to an injection well. The reservoir has a depth of 3600 meters, with a minimum horizontal stress (Sh) of 40 MPa and a maximum horizontal stress (SH) of 80 MPa. The initial pore pressure is set at 30 MPa. I'm facing challenges in achieving equilibrium in the model under these conditions, aiming for no deformation and no crack growth under the specified stresses. Any guidance or assistance would be greatly appreciated. I am using the poroelastic interface by the way. Thank you.
Hello El Mustapha Guellal
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.