Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Running a specific Study node using batch
Posted 2013年1月10日 GMT-0500上午11:44 Version 4.4 3 Replies
I would like to run a specific Study node (suppose I have a model with 2 or more Study nodes) using batch commands. Normally I write something like
comsol -nn 8 -np 8 batch -inputfile input.mph -outputfile output.mph -batchlog batch.log
Does anyone know which additional command I should issue to be able to select a specific Study node to run?