Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Can the elastic matrix be modified by oneself in Solid Mechanics model?

Posted 2016年7月22日 GMT-4 07:01 Structural Mechanics Version 4.3 2 Replies

Jia Liu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi

We all know that elastic module E and Possion's ratio mu are needed in Solid Mechanics model. Then, the elastic matrix is assembled according to both of them. however, a NEW elastic matrix can be assembled by oneself ? In other words, different domains own different constitutive relations in a model.

Thanks a lot!
2 Replies Last Post 2016年10月18日 GMT-4 04:48
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 2016年7月22日 GMT-4 13:20
Hi,

If you change the Linear Elastic material model from Isotropic to Anisotropic, the input is the elements of a general elastic constitutive matrix.

Regards,
Henrik
Hi, If you change the Linear Elastic material model from Isotropic to Anisotropic, the input is the elements of a general elastic constitutive matrix. Regards, Henrik
Jia Liu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 2016年10月18日 GMT-4 04:48
Thank you very much! This problem had been solved.
Thank you very much! This problem had been solved.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content