Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Import a matrix to draw a 3D surface In Comsol 3.5a

Please login with a confirmed email address before reporting spam

Hello
I am new to Comsol about importing data in software, I make a Picture descrbing this thing.

Please everyone who can help me.

Thank you


4 Replies Last Post 2011年6月10日 GMT-4 23:16
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年6月9日 GMT-4 03:47
Hi

check/search the forum, there are at least 2 ways described herein (and new possibilities in v4.2)

--
Good luck
Ivar
Hi check/search the forum, there are at least 2 ways described herein (and new possibilities in v4.2) -- Good luck Ivar

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年6月9日 GMT-4 03:54
Please tell me what is the key word to this forum about What I need ?

Thank you.
Please tell me what is the key word to this forum about What I need ? Thank you.

Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年6月9日 GMT-4 04:09
Hi

what about trying "import data" in the Forum Search

or "geom_from_file_test_with_classeur1.txt.mph"

--
Good luck
Ivar
Hi what about trying "import data" in the Forum Search or "geom_from_file_test_with_classeur1.txt.mph" -- Good luck Ivar

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年6月10日 GMT-4 23:16
Thank you for your replying my question but I can't read the file because my version is not Comsol 4

Is any possible that I could use the Matlab or other way to construct the 3D surface from the matrix in .txt (or .xls) file

by using Comsol 3.5a (& script)



Thank you
Thank you for your replying my question but I can't read the file because my version is not Comsol 4 Is any possible that I could use the Matlab or other way to construct the 3D surface from the matrix in .txt (or .xls) file by using Comsol 3.5a (& script) Thank you

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.