Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Weak term in 4.1

Please login with a confirmed email address before reporting spam

Dear, all

I am just following the model "www.comsol.com/community/exchange/118/"

which is modeling the free surface motion.

That is made in version 3.5 a

I found difficulty in the WEAK TAB

3.5 : Equation system >Physics>Boundary settings>Weak>Pressure>u, v

4.1 : Laminar flow>weak contribution(?)

There are no "u, v" tab in 4.1 weak contribution .

How can i apply 3.5 boundary condition to the same in 4.1 ?

Any comments will be appreciated.



2 Replies Last Post 2011年9月6日 GMT-4 06:36
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年9月6日 GMT-4 04:37
Hi

in V4 you type in your equations, with the variables you need, to see them and to cmpare to 3.5 the easiest is to turn on the equation view (sub-nodes) and compare from there

The GUIs are different, but the underlying eqautions are the same to the variable naming convention that differ a bit ;)

--
Good luck
Ivar
Hi in V4 you type in your equations, with the variables you need, to see them and to cmpare to 3.5 the easiest is to turn on the equation view (sub-nodes) and compare from there The GUIs are different, but the underlying eqautions are the same to the variable naming convention that differ a bit ;) -- Good luck Ivar

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年9月6日 GMT-4 06:36
Great Thanks :)
Great Thanks :)

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.