Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Error in using the none unit system while using extmat.

Please login with a confirmed email address before reporting spam

As soon as I change the units in COMSOL from SI to none, I get the following error:

Error in multiphysics compilation. Tensor index out of bounds

I am doing a transitent study using solid mechanics interface and external material (external stress-strain relation). The model runs just fine when the unit system is SI. I have also ensured that components are using the same unit system as the global system. I think I have to make some changes in my extmat code (written in C) but am not sure what exactly might be the source of error.


0 Replies Last Post 2023年7月20日 GMT-4 12:56
COMSOL Moderator

Hello Prakhar Bandil

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.