Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

EFFECTIVE INDEX

Posted 2012年12月12日 GMT-5 23:09 Version 4.3 3 Replies

J.N Dash
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi eveybody. Actually I am trying to plot effective index of PCF with variation of diameter in COMSOL.I could not know how to put the diameter values and where to put.Please help me in this regard.I am using version 4.3.0.151.Thank you.
3 Replies Last Post 2012年12月15日 GMT-5 09:26
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年12月13日 GMT-5 01:33
Hi

check the Results derived variable node, and populate this one for your effetve index, this should make a table, that you can then plot by clicking on the "plot" icon of the table tab

--
Good luck
Ivar
Hi check the Results derived variable node, and populate this one for your effetve index, this should make a table, that you can then plot by clicking on the "plot" icon of the table tab -- Good luck Ivar
J.N Dash
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年12月14日 GMT-5 08:38
Thank you sir.
Thank you sir.
J.N Dash
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年12月15日 GMT-5 09:26
Hi
do I have to define a relation between diameter and effective index first in parametric section COMSOL 4.3.151? Is parametric sweep is needed ?Thank you
Hi do I have to define a relation between diameter and effective index first in parametric section COMSOL 4.3.151? Is parametric sweep is needed ?Thank you

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content