Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Coil Inductor Simulation With Electric and Induction Currents(AC/DC)
Posted 2010年7月28日 GMT-4 00:46 0 Replies
Please login with a confirmed email address before reporting spam
I am trying to simulate a coil inductor on PCB. I have a copper coil on PCB.(As shown on Fig.1)
I am applying 1A Fixed current density
I am solving this using Direct UMFPACK Solver.
The magnetic flux density I am getting is very small.
The streamline of magnetic flux density and Total current density looks incorrect for me.
The total current density is around the coil and through out the length of the coil, the magnetic flux density
is in plane parallel to the coil. (See Figure 2 and Figure 3)
Can any one please verify and tell me what is wrong.
What parameter needs to be changed to get higher value of Magnetic flux density
Thanks and Regards
ERaja Ma
Attachments:
Hello ERaja Ma
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.