Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Meshing a Dome

Posted 2010年7月28日 GMT-4 05:50 1 Reply

Andy Tomlinson
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

Can anyone help me in meshing this dome.

I tried to mesh with Free Tetrahedral but that gives an error "A degenerated triangle was created".

And Swept mesh didn't work.


Thanks
Andy

Attachments:

1 Reply Last Post 2010年7月28日 GMT-4 06:15
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2010年7月28日 GMT-4 06:15
Hi

one limitations in 3.5 at least (not sure about 4) is that a revolve mesh (not sweep) requires quads on the axis, but only if the axis is part of the "revolve", one can always transform the resulting prisms to thets witht the convert, or add a tine hole at the axis and fill it in later, if required

--
Good luck
Ivar
Hi one limitations in 3.5 at least (not sure about 4) is that a revolve mesh (not sweep) requires quads on the axis, but only if the axis is part of the "revolve", one can always transform the resulting prisms to thets witht the convert, or add a tine hole at the axis and fill it in later, if required -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content