Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
How to obtain the unit $\mu$
Posted 2010年10月13日 GMT-4 05:55 3 Replies
Please login with a confirmed email address before reporting spam
Hi all,
I have a simple/stupid/quick (pick the good one) question for Comsol 4.0(a).
I want to use the symbol ? in my legend (or unit while computing). Of course I can specify it in the geometry (?m), but after, everything is in meter.
How should I do to obtain the symbol corresponding to micro- ?
Best regards
I have a simple/stupid/quick (pick the good one) question for Comsol 4.0(a).
I want to use the symbol ? in my legend (or unit while computing). Of course I can specify it in the geometry (?m), but after, everything is in meter.
How should I do to obtain the symbol corresponding to micro- ?
Best regards
3 Replies Last Post 2010年10月13日 GMT-4 08:01
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Ok, I will reply to myself for the legends :
I just had to write "\mu".
the trick doesn't work in expression though... so if someone has an answer...
I just had to write "\mu".
the trick doesn't work in expression though... so if someone has an answer...
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
There are several options here:
- Some keyboards have µ as a special character that you access with the AltGr button (on the M key, for example). You can then specify a dimension as 4.5[µm], for example.
- You can replace µ with u as an SI prefix for "micro" in units, so 4.5[um] works fine, too.
- For the geometry you can use µm as the length unit. COMSOL then interprets all numbers that you enter for the geometry as micrometers unless you explicitly specify the unit.
Hope this helps,
Magnus Ringh, COMSOL
- Some keyboards have µ as a special character that you access with the AltGr button (on the M key, for example). You can then specify a dimension as 4.5[µm], for example.
- You can replace µ with u as an SI prefix for "micro" in units, so 4.5[um] works fine, too.
- For the geometry you can use µm as the length unit. COMSOL then interprets all numbers that you enter for the geometry as micrometers unless you explicitly specify the unit.
Hope this helps,
Magnus Ringh, COMSOL
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Thank you very much for your answer Magnus.