Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

3D capacitive pressure sensor analysis in COMSOL 3.2.0

Posted 2010年10月13日 GMT-4 06:35 0 Replies

Ashwin Simha
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear All,

I have been using COMSOL for a few months now . I would like to analyse a MEMS 3D capacitive pressure sensor. I tried to couple Electrostatic ,solid stress strain module along with the moving mesh(ALE) but I get a message ' fatal error '. Could someone share with me the detailed procedure for coupling these subdomains. Please find attached the simple geometry I would like to use. The middle rectangular plate represents air and other two rectangular plates represents the plates of the capacitor.

Thanks in advance,

Best regards,
Ashwin Simha.
NITK Surathkal.

Attachments:

0 Replies Last Post 2010年10月13日 GMT-4 06:35
COMSOL Moderator

Hello Ashwin Simha

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content