Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

About particle simulation

Please login with a confirmed email address before reporting spam

Background: simulate the particles flow through narrow gap
The module I used is particle tracing for fluid flow.

I set particle diameter-10um, but the particles can still pass through 2um and 5um gap, as indicated in my attached image. Also, changing the diameter of the particles did not alter the trajectories.

Any help is greatly appreciated! I can provide more details if needed.

Thank you all,
Chao


0 Replies Last Post 2016年4月21日 GMT-4 23:47
COMSOL Moderator

Hello 超 容

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.