Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

About evaluating at a specific time

Posted 2016年4月25日 GMT-4 19:58 Heat Transfer & Phase Change Version 5.1 2 Replies

Zhenhuan Xu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

When I ran the simulation, the time step is 0.2s, so I can only evaluate at t=1.00 and t=1.2, is there any way to evaluate at t at any time between 1 and 1.2?

Thanks,
Zhenhuan
2 Replies Last Post 2016年4月27日 GMT-4 08:49
Mathieu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 2016年4月26日 GMT-4 09:53
Hello,

You can choose "interpolation" insteed of "1" or "1.2" (after your last time). Then you just have to choose the time you want.

Regards
Hello, You can choose "interpolation" insteed of "1" or "1.2" (after your last time). Then you just have to choose the time you want. Regards
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 2016年4月27日 GMT-4 08:49
Depending on what you're trying to achieve, you may want to also look into using the "at" operator. Its use is documented in the COMSOL Multiphysics Reference Manual, version 5.2, page 230.
Best regards,
Jeff
Depending on what you're trying to achieve, you may want to also look into using the "at" operator. Its use is documented in the COMSOL Multiphysics Reference Manual, version 5.2, page 230. Best regards, Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content