Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Use 2D axisymmetric solution as initial values in 3D

Posted 2010年11月16日 GMT-5 09:55 0 Replies

Simon L.
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear all,

my non-isothermal flow problem is axisymmetric with a weak perturbation breaking this symmetry. I therefore want to use the easily converging 2D axisymmetric solution as initial values for solving the 3D problem. I already tried to use the general extrusion coupling and can create nice 3D plots of the revolved 2D solution. But I did not succeed to use it in the initial values. How is this done in Comsol 4.0?

Regards,
Simon
0 Replies Last Post 2010年11月16日 GMT-5 09:55
COMSOL Moderator

Hello Simon L.

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content