Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Twist 3 D pipe

Posted 2016年7月5日 GMT-4 07:29 Geometry 1 Reply

Moayad Al Sheikh Hassan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,
I draw 3 D pipe. After that i want (twist) this pipe with angel (90) but i dont' know the method.
My question: How can i twist this pipe?
Thanks,

Attachments:

1 Reply Last Post 2016年7月12日 GMT-4 16:37
Sohan Birla
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 2016年7月12日 GMT-4 16:37
You can draw cross section of pie (ellipse) in a workplane and use extrude feature and provide twist angle there.
You can draw cross section of pie (ellipse) in a workplane and use extrude feature and provide twist angle there.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content