Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

New to comsol: Overriding

Posted 2016年7月18日 GMT-4 02:29 1 Reply

Vamsi Manda
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

How do you override boundary conditions?
I need one of my walls to be a wetted wall,but i am unable to make it so because in the boundaries section ,(not applicable) is being shown
1 Reply Last Post 2016年7月19日 GMT-4 16:40
Chris Nadovich
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 2016年7月19日 GMT-4 16:40
I don't know your Physics, but if COMSOL says "Not Applicable" it's not just annoying you. You don't want to "override", rather you need to think about what the boundary condition means and why you can't have what you want. In my electromagnetics physics, sometimes I'll want a passive boundary on top of a port I'm driving with a field. So I'm a dummy. Can't have both at the same place. It's like that.
I don't know your Physics, but if COMSOL says "Not Applicable" it's not just annoying you. You don't want to "override", rather you need to think about what the boundary condition means and why you can't have what you want. In my electromagnetics physics, sometimes I'll want a passive boundary on top of a port I'm driving with a field. So I'm a dummy. Can't have both at the same place. It's like that.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content