Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Interior wall in free and porous media flow physics
Posted 2016年9月21日 GMT-4 16:04 Fluid & Heat, Computational Fluid Dynamics (CFD), Modeling Tools & Definitions, Parameters, Variables, & Functions Version 5.1 1 Reply
Please login with a confirmed email address before reporting spam
I have filter model which i did cfd analysis in both laminar and free and porous media flow .
The red marked part (attached below) is rectangular plate which acts like a interior wall where the air-flow mixture after entering through the inlet hits the rectangular plate and diverts into different flow direction.
(Note :The air flow mixture doesn't go into the rectangular plate ,the plate is kept for diverting the flow into directions ).
In laminar physics i have given interior wall option but when coming to the free and porous media flow there is no interior wall option so i tried wall and gave slip but there is no use and also the whole plate is not selecting only the edge is been selecting don't know why ?
So what should i do know ?
please suggest me
Thanks in advance
Regards
The comsol model is attached below (sep10)
The picture which shows the plate is also attached below(1234.jpg)
The red marked part (attached below) is rectangular plate which acts like a interior wall where the air-flow mixture after entering through the inlet hits the rectangular plate and diverts into different flow direction.
(Note :The air flow mixture doesn't go into the rectangular plate ,the plate is kept for diverting the flow into directions ).
In laminar physics i have given interior wall option but when coming to the free and porous media flow there is no interior wall option so i tried wall and gave slip but there is no use and also the whole plate is not selecting only the edge is been selecting don't know why ?
So what should i do know ?
please suggest me
Thanks in advance
Regards
The comsol model is attached below (sep10)
The picture which shows the plate is also attached below(1234.jpg)
Attachments:
1 Reply Last Post 2016年9月23日 GMT-4 01:17
Please login with a confirmed email address before reporting spam
Posted:
8 years ago
Hi,
You can use laminar flow domain and enable porous media as a sub-domain within that (by clicking one of the check boxes). With that you'll be able to use all the attributes of the laminar flow domain within your porous media sub-domain. Hope that helps.
You can use laminar flow domain and enable porous media as a sub-domain within that (by clicking one of the check boxes). With that you'll be able to use all the attributes of the laminar flow domain within your porous media sub-domain. Hope that helps.