Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

simple question: Connect feed to resonator cavity

Posted 2016年10月6日 GMT-4 04:46 1 Reply

Ashley MC Donald
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi! I'm new with comsol and I have a simple question: How can I connect the coaxial cable in figure with the resonator cavity?


Thanks
1 Reply Last Post 2016年10月6日 GMT-4 11:01
Dave Greve
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 2016年10月6日 GMT-4 11:01
I don't see a coaxial cable in either of your images.

However in general- the ways to couple a coaxial cable to a cylindrical cavity can be found in one of the standard texts, for example, Ramo Whinnery and van Duzer. Often a short extension of the coaxial cable center conductor is inserted into the cavity.

In Comsol you probably need to put a port at the other end of the coaxial cable and then extract S parameters or impedance after doing the EM field calculation.

DW Greve
I don't see a coaxial cable in either of your images. However in general- the ways to couple a coaxial cable to a cylindrical cavity can be found in one of the standard texts, for example, Ramo Whinnery and van Duzer. Often a short extension of the coaxial cable center conductor is inserted into the cavity. In Comsol you probably need to put a port at the other end of the coaxial cable and then extract S parameters or impedance after doing the EM field calculation. DW Greve

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content