Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Inlet stream under an angle

Posted 2016年10月11日 GMT-4 10:04 Fluid & Heat, Geometry, Studies & Solvers Version 4.2a 2 Replies

Lili Hauzer
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I want to simulate a fluid flow that enters a room under an angle. I can't use a cylinder (which I rotated to achieve the right angle), because I am not able to use one end as an inlet and I don't know why. Can anybody help me out?
2 Replies Last Post 2016年10月13日 GMT-4 04:15
Sohan Birla
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 2016年10月11日 GMT-4 14:39
Inspect the geometry model as you might have created the surface only for cylinder.

Inspect the geometry model as you might have created the surface only for cylinder.
Lili Hauzer
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 2016年10月13日 GMT-4 04:15
Dear mr Birla,
Thank you for your response. All parts of my model are solid. After I made a union, I sometimes get the error that there is a segregated group. The flow also diverges regarding the model while it should become stationary... Do you know any other settings where I can take a look at? All hints are welcome...
Dear mr Birla, Thank you for your response. All parts of my model are solid. After I made a union, I sometimes get the error that there is a segregated group. The flow also diverges regarding the model while it should become stationary... Do you know any other settings where I can take a look at? All hints are welcome...

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content