Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
2D Initial Conditions
Posted 2016年11月7日 GMT-5 05:34 Heat Transfer & Phase Change, Chemical Reaction Engineering Version 5.2 1 Reply
Please login with a confirmed email address before reporting spam
Hello Everyone!
I am working on adsorption heat pumps where there are 2 stages called 'adsorption' and 'regeneration'.The
initial conditions of regeneration phase is the ending conditions of adsorption phase. Since I am working on 2D model, somehow I have to put these 2D data as initial condition (temperature profile or concentration profile) and I couldn't figure out how to it.
Any ideas?
Thanks in advance.
I am working on adsorption heat pumps where there are 2 stages called 'adsorption' and 'regeneration'.The
initial conditions of regeneration phase is the ending conditions of adsorption phase. Since I am working on 2D model, somehow I have to put these 2D data as initial condition (temperature profile or concentration profile) and I couldn't figure out how to it.
Any ideas?
Thanks in advance.
1 Reply Last Post 2016年11月7日 GMT-5 12:32
Please login with a confirmed email address before reporting spam
Posted:
8 years ago
Hello Talha,
It's in the study step settings that you specify where the initial values for the dependent variables are taken from. See Reference Manual, version 5.2a, page 921 and following. All manuals are accessed through File > Help >Documentation.
Best,
Jeff
It's in the study step settings that you specify where the initial values for the dependent variables are taken from. See Reference Manual, version 5.2a, page 921 and following. All manuals are accessed through File > Help >Documentation.
Best,
Jeff