Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Does Comsol allow only continuous flow ?

Posted 2016年11月9日 GMT-5 07:14 Fluid & Heat, Computational Fluid Dynamics (CFD), Microfluidics Version 4.3a 2 Replies

Nidhin T Madhu
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Is it possible only to simulate continuous flow in Comsol multiphysics where the liquid is available at the inlet continuously and it leaves at the outlet?
How to give the boundary conditions where the fluid flow get stopped as there is no available liquid for flow? How to define the domain in such cases?
2 Replies Last Post 2017年4月12日 GMT-4 10:05
COMSOL Moderator

Hello Nidhin T Madhu

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Reza Ansari Shirvan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 2017年4月11日 GMT-4 08:31
Hi,

I think you need to carry out transient simulation for this case. You can also add a COMSOL function at the inlet boundary in order to define mass flow rate decay.

look at my answer here:
www.comsol.dk/community/forums/cfd/thread/139992/
www.comsol.dk/community/forums/cfd/thread/138371/

Best regards,
Reza
Hi, I think you need to carry out transient simulation for this case. You can also add a COMSOL function at the inlet boundary in order to define mass flow rate decay. look at my answer here: https://www.comsol.dk/community/forums/cfd/thread/139992/ https://www.comsol.dk/community/forums/cfd/thread/138371/ Best regards, Reza
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 2017年4月12日 GMT-4 10:05
Depending on what physical phenomena you are trying to simulate, you may also want to dig more into COMSOL's capabilities for multiphase flow simulations (CFD Module and Microfluidics Module). A starting point on that topic is this blog post:
www.comsol.com/blogs/which-multiphase-flow-interface-should-i-use/
Best regards,
Jeff
Depending on what physical phenomena you are trying to simulate, you may also want to dig more into COMSOL's capabilities for multiphase flow simulations (CFD Module and Microfluidics Module). A starting point on that topic is this blog post: https://www.comsol.com/blogs/which-multiphase-flow-interface-should-i-use/ Best regards, Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content