Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
modelling end inductance and end resistance of an induction motor
Posted 2016年12月18日 GMT-5 11:36 Low-Frequency Electromagnetics, Mesh, Results & Visualization, Studies & Solvers Version 5.2a 1 Reply
Please login with a confirmed email address before reporting spam
Hi,
I am trying to model end winding resistance and end inductance of an Induction motor using electric circuit interface. My model works fine and produces good results when I keep only resistance with External I Vs. U . As soon as I connect with inductor, resistance and External I Vs. U 1, my model doesnot converge. Can any one suggest what is going on wrong here?
With best regards,
Gaurav
I am trying to model end winding resistance and end inductance of an Induction motor using electric circuit interface. My model works fine and produces good results when I keep only resistance with External I Vs. U . As soon as I connect with inductor, resistance and External I Vs. U 1, my model doesnot converge. Can any one suggest what is going on wrong here?
With best regards,
Gaurav
1 Reply Last Post 2016年12月26日 GMT-5 02:30
Please login with a confirmed email address before reporting spam
Posted:
8 years ago
Now further if I follow ""Solver configurations >> Time dependent Solver >> Settings >> Time stepping >> Error estimate >> Exclude algebraic". Solution converges but voltage across the coil doesnot come good. Can anyone suggest what could be wrong here?
With best regards,
Gaurav
With best regards,
Gaurav