Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

matlab problem

Please login with a confirmed email address before reporting spam

Hello everyone

i v just joined the forum and i would like u to give me some sort of help in my induction motor project
i am using matlab to carry out the value for torque and then plot the torque Vs speed graph using matlab

so i am given the parameters
I2=5.42A
R2=.8?

to carry out the torque values for (rotor speeds(wr)=from 0-50rad/s)

knowing that slip=s=0 when wr=50rad/s
and slip=1 when wr=0

Torque=(3/wr)*(I2^2) * {R2(1-s)/s}
To sum up i want to produce a torque speed plot using matlab

i suppose that i can do that using for loop
i think that it is not hard but i am not that good in matlab

here is my little attempt

for I2=5.42

for R2=.8
for s=.02
torque=(3/wr)*{(i2)^2}*{(r/s)*(1-s)}

plz help!
torqueplot

0 Replies Last Post 2009年10月25日 GMT-4 16:20
COMSOL Moderator

Hello fdsfsd fss

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.