Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

not converged in spite of the low error value

Posted 2017年1月22日 GMT+8 00:59 Studies & Solvers Version 5.2, Version 5.2a 2 Replies

Michael Potter
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam


Hi,
I'm modeling a reactor with turbulent fluid flow and heat transfer and got really confused. The Nonlinear
solver reaches the error value lower than 1e-10 however the solver dose not stop the calculation. Could any one assist me with this problem?
2 Replies Last Post 2017年1月27日 GMT+8 00:54
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 2017年1月24日 GMT+8 15:58
Hi,

There are several criteria which need to be fulfilled for a solution to be considered as converged.

Maybe the discussions in

www.comsol.com/community/forums/general/thread/35375

can be of some help.

Regards,
Henrik
Hi, There are several criteria which need to be fulfilled for a solution to be considered as converged. Maybe the discussions in https://www.comsol.com/community/forums/general/thread/35375 can be of some help. Regards, Henrik
Michael Potter
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 2017年1月27日 GMT+8 00:54
Hi ,
Dear Henrik,
Thank's for your reply.
I read that page and your explanation completely.
The damping factor for my case was descended.
I have three questions:
1- What should be done to prevent this happening ?
2- Does setting termination criteria to be "solution or residual" help solve this problem ?
3- I want to know what is the reason for the statement :
"it is required that the damping factor in the Newton solver is 1 before the solution is accepted"
Could you introduce some references for further study ?

Best regards
Michael Potter
Hi , Dear Henrik, Thank's for your reply. I read that page and your explanation completely. The damping factor for my case was descended. I have three questions: 1- What should be done to prevent this happening ? 2- Does setting termination criteria to be "solution or residual" help solve this problem ? 3- I want to know what is the reason for the statement : "it is required that the damping factor in the Newton solver is 1 before the solution is accepted" Could you introduce some references for further study ? Best regards Michael Potter

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content