Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Cable model with point mass

Please login with a confirmed email address before reporting spam

Hello everyone,

i modelled a prestressed cable with truss element (both tried in 2D and 3D) and used the "prestressed analysis, eigenfrequency" to obtain the natural frequencies of the system.
Now i would like to add a point mass in the center point of the cable but when i add the central node the analysis doesn't work because, i think, it adds other dofs to the system.
I tried to build two diffrent polygon, to add the central point or to divide the polygon into two with the work plane but non of those work.
If i use form assembly insted of form union with the added central point, the analyis works but it doesnt take account of the punctual mass.

Any help would be appreciated.
Thanks in advice,
Erick.

0 Replies Last Post 2017年1月23日 GMT-5 07:32
COMSOL Moderator

Hello Erick Alaimo

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.