Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

"Line current (out of plane)" and "Electric point dipole" power

Posted 2017年2月20日 GMT-5 11:15 RF & Microwave Engineering Version 4.2a 0 Replies

Ugo Stella
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear All,
I do 2D simulations of multilayered structures. I am using "Line current (out of plane)" or "Electric point dipole" as sources. I would like to know how can I set the value of I0 and the value of P in the two cases in such a way that the power injected in the simulations by the two sources is the same.

Thank you.
Ugo
0 Replies Last Post 2017年2月20日 GMT-5 11:15
COMSOL Moderator

Hello Ugo Stella

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content