Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Eddy Curents in coil group domain

Posted 2011年2月24日 GMT-5 05:18 Low-Frequency Electromagnetics Version 4.1 2 Replies

Matthias Birle
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I'v worked some days with comsol 4.1 and h'v tried multiturn, singleturn and coil-group-domain conditions in 2D axialsymetric. There is skin and proximity effect and I think it works good. Eddy currents in additional domains works also fine. But how to set up the right conditions for some domains (wich schould be a coil-group-domain) to get eddy curents in an coil in 2D axialsymetric. Hope you understand my request.

Thanks a lot.

Attachments:

2 Replies Last Post 2011年2月24日 GMT-5 09:58
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年2月24日 GMT-5 09:23
Hi

two comments, one on your geometry, if your coil "touches", you have a contact point that is not very clearly defined, I would keep them "just not touching"

for the induced current I would look at "mef.Jiphi" and not "mef.normJ"

check the underlaying equations

--
Good luck
Ivar
Hi two comments, one on your geometry, if your coil "touches", you have a contact point that is not very clearly defined, I would keep them "just not touching" for the induced current I would look at "mef.Jiphi" and not "mef.normJ" check the underlaying equations -- Good luck Ivar
Matthias Birle
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2011年2月24日 GMT-5 09:58
Hi Ivar, thanks for your quick reply and the advice with the "touches". That was not intended. I'll check the "mef.Jiphi".

Thanks a lot.
Hi Ivar, thanks for your quick reply and the advice with the "touches". That was not intended. I'll check the "mef.Jiphi". Thanks a lot.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content