Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Extracting Length of Boundary

Please login with a confirmed email address before reporting spam

At the end of my simulation, I take a "Line Average" of a few of my boundaries. I click on the *one* boundary I want to inspect, then get "es.nD" and "V" parameters for the boundary when I hit "evaluate". My solution is a parametric sweep, so it gives me those values for every parameter in my sweep.

Extracting the length requires me to go back into my geometry and measure each length individually for each parameter and then match everything up. I could also calculate it based on the parameters I set, but again I would have to match it up afterwards.

Is there some variable that will just return the length of my boundary?

2 Replies Last Post 2017年6月14日 GMT-4 13:10
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 2017年6月14日 GMT-4 12:20
Hi Thomas,
Integrating 1 along a line will give you its length.
Jeff
Hi Thomas, Integrating 1 along a line will give you its length. Jeff

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 2017年6月14日 GMT-4 13:10
Awesome! Thank you! :D
Awesome! Thank you! :D

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.