Discussion Forum

Forum Home

New Discussion

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How can I optimize the Time-step in Time-dependent analysis

Posted 2017年6月22日 GMT-4 08:27 2 Replies

NDN UNIST/Mechanical Engineering

Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all

I am doing the Time dependent study for Particle Tracing for Fluid flow. But actually I am clear the value of Time-step.
If we consider two case of Time range as:
Case 1: range(0,1,10)
Case 2: range(0,0.01,10)

Both begin with 0s and end with 10s but only different by Time-step.

So, which value of time-step is better ? is more accurate ? And the result of simulation is same or different ?

thanks so much for your reading my topic

2 Replies Last Post 2017年6月22日 GMT-4 11:42

Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 7 years ago

There have been several discussions on this topic in the Discussion Forum. You will find them with a search.
One for instance that discusses the relation to tolerances and accuracy is this one: www.comsol.com/community/forums/general/thread/50111
See also this one where it is explained why the final time impacts the entire solution:
www.comsol.com/community/forums/general/thread/108101
Best,
Jeff

NDN UNIST/Mechanical Engineering

Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 7 years ago

Thanks so much, Dr.Jeff Hiller

Note that while COMSOL employees may participate in the discussion forum, COMSOL^® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Discussion Forum

How can I optimize the Time-step in Time-dependent analysis

Suggested Content