Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

magnetic flux density (B) and magnetic field (H) in a simple solenoid

Posted 2011年3月7日 GMT-5 14:27 0 Replies

Ângela Ferreira
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I found some strange results using the magnetic field solution in a complex geometry, so I have tried simple ones, as described below.

Considering the interior of a solenoid with a linearized soft ferromagnetic material (say relative permeability 1000), the solution for the magnetic field H inside the solenoid is different from the obtained with the soft ferromagnetic material replaced by air. I was expecting the same results for the magnetic field H. What may be wrong?

Thanking in advance.

0 Replies Last Post 2011年3月7日 GMT-5 14:27
COMSOL Moderator

Hello Ângela Ferreira

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content