Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Magnetic Flux Leakage

Samaneh Hosseingholizadeh

Please login with a confirmed email address before reporting spam

Hi All, I am trying to model the magnetic flux leakage in a plate which is magnetized by two coils wound around a yoke shape magnetic core. The is an air gap between the plate and the magnetic core. The plate has a rectangular discontinuity, so the magnetic field should leak out to the air. However, when I run the model I see this error: "Failed to find consistent initial values. Last time step is not converged." The file is attached. I would appetite it if any one can help me with this.



2 Replies Last Post 2017年9月19日 GMT-4 16:56
Nirmal Paudel Tribhuvan University/Electrical Engineering

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 2017年9月19日 GMT-4 16:45

Hi There,

The following two examples seems to be useful here. https://www.comsol.com/model/e-core-transformer-14123 https://www.comsol.com/model/vector-hysteresis-modeling-20671

Best Regards, Nirmal Paudel

Hi There, The following two examples seems to be useful here. https://www.comsol.com/model/e-core-transformer-14123 https://www.comsol.com/model/vector-hysteresis-modeling-20671 Best Regards, Nirmal Paudel

Samaneh Hosseingholizadeh

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 2017年9月19日 GMT-4 16:56

Hi There,

The following two examples seems to be useful here. https://www.comsol.com/model/e-core-transformer-14123 https://www.comsol.com/model/vector-hysteresis-modeling-20671

Best Regards, Nirmal Paudel

Hi Nirmal, Thanks for your response. Actually I did both tutorials, but I did not see any magnetic flux leakage into the air when I made a discontitunuty in the ferromagnetic core.

>Hi There, > >The following two examples seems to be useful here. >https://www.comsol.com/model/e-core-transformer-14123 >https://www.comsol.com/model/vector-hysteresis-modeling-20671 > >Best Regards, >Nirmal Paudel Hi Nirmal, Thanks for your response. Actually I did both tutorials, but I did not see any magnetic flux leakage into the air when I made a discontitunuty in the ferromagnetic core.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.