Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Drag Torque Analysis for Wet Clutch

Posted 2017年11月3日 GMT-4 08:15 0 Replies

Suraj Sukumaran
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello!

Can any one please help me in sorting out the right method to setup the position of interface tracking bewteen oil & air using VOF method for Wet Clutch.

I have performed this analysis using steady state level set method in 2D Geometry.

Vof is not properly tracked in my case and always shows up the initial phases.

Attachments:

0 Replies Last Post 2017年11月3日 GMT-4 08:15
COMSOL Moderator

Hello Suraj Sukumaran

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content