Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
creating a contact boundary condition
Posted 2009年7月9日 GMT-4 14:25 2 Replies
Please login with a confirmed email address before reporting spam
Hi,
I am trying to model the contact surfaces of two objects. At room temperature, both surfaces are in tight fit situation, which there is pressure on both surfaces. As the surrounding temperature goes up, the two objects having negative coefficients of thermal expansion will shrink and a gap should be formed between the two surfaces.
I drew 2 rectangles representing the 2 objects, however, the contacting surfaces were interpreted as an interior boundary when I tried to specify the boundary conditions. The result seemed to considered both objects as one whole.
Is there any way I can specify that on that same line, there are 2 different surfaces? Thank you for any advice.
John
I am trying to model the contact surfaces of two objects. At room temperature, both surfaces are in tight fit situation, which there is pressure on both surfaces. As the surrounding temperature goes up, the two objects having negative coefficients of thermal expansion will shrink and a gap should be formed between the two surfaces.
I drew 2 rectangles representing the 2 objects, however, the contacting surfaces were interpreted as an interior boundary when I tried to specify the boundary conditions. The result seemed to considered both objects as one whole.
Is there any way I can specify that on that same line, there are 2 different surfaces? Thank you for any advice.
John
2 Replies Last Post 2009年7月15日 GMT-4 11:12
Please login with a confirmed email address before reporting spam
Posted:
2 decades ago
Dear John,
I think that your problem is related with the geometry of your model.
You have to use the assembly mode with contact pair.
You can find the assembly mode and contact pair options under the draw menu.
Eros
I think that your problem is related with the geometry of your model.
You have to use the assembly mode with contact pair.
You can find the assembly mode and contact pair options under the draw menu.
Eros
Please login with a confirmed email address before reporting spam
Posted:
2 decades ago