Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Modelling Linear Water Waves with porous media
Posted 2011年4月26日 GMT-4 04:42 Fluid & Heat, Mesh Version 3.5a 0 Replies
Please login with a confirmed email address before reporting spam
I'm fairly new to COMSOL Multiphysics so I apologise for my ignorance.
I am wanting to model linear water waves passing over/through porous media (e.g. a porous breakwater). I was given a model that uses both Moving Mesh (ALE) and the Incompressible Navier-Stokes (ns) application modes. However, I am unable to see where to put parameters such as porosity.
I would like to achieve something similar to Martinelli found at: www.comsol.com/papers/1564/
However I would like the breakwater to be fixed, submerged and to be porous.
I have also noticed that the Earth Sciences module has Brinkman Equations which state they can be used for modelling porous media. I have tried this application mode to no avail and get the error message "Failed to evaluate expression for manual time step".
I was wondering if the Incompressible Navier-Stokes application mode (under COMSOL Multiphysics > Fluid Dynamics) could be used to model a porous breakwater?
Thank you in advance!
Hello Jamie Wong
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.