Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Anisotropic-rotation of compliance matrix-solid mechanics

Posted 2018年4月19日 GMT-4 20:01 Structural & Acoustics, Geomechanics Version 5.2 0 Replies

Nima Danesh
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Dear all,

I am running a linear anisotropic model in 3D using solid mechanics module (Please find the geometry and boundary conditions in the attached photo). I would like to rotate the compliance matrix components at a certain angle. Here, I have several questions to raise:

1- Should I use Euler angles to do that? In other words, do Euler angles rotate anisotropic properties? 2- Do the tractions change if I apply Euler angles to my model? 3- Is it possible to implement non-linear elastic behaviour in linear elastic material settings in COMSOL? 4- How can I apply shear stress on a boundary in COMSOL settings?

Thanks very much for your help in advance.

Regards, Nima

Attachments:

0 Replies Last Post 2018年4月19日 GMT-4 20:01
COMSOL Moderator

Hello Nima Danesh

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content