Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Adding Geometry Between Studies (Heat Transfer)

Suraj Kumar Rana Bhat

Please login with a confirmed email address before reporting spam

I am trying to model a simple time dependent heat transfer problem in solid.

A hot 3D plate with LxBxH = (1mx1mx0.2m) is exposed to ambient air and allowed to cool from top surface under convection for 2 hours. After 2 hour, a second hot plate of same dimension is placed on top of previous cooling plate. And same process repeated adding more plates on top of previous one.

Now my question is, how can I add geometry in the middle of simulation such that I will get one complete temperature result?


0 Replies Last Post 2018年8月8日 GMT-4 06:48
COMSOL Moderator

Hello Suraj Kumar Rana Bhat

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.