Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

3D geometry selection comsol 3.5a

Posted 2011年7月13日 GMT-4 12:28 Geometry, Modeling Tools & Definitions, Parameters, Variables, & Functions Version 3.5a 0 Replies

Kim Smith
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam


Hi,

I am fairly new to comsol and am using the 3.5 version.

My problem,

I have a 3D airfoil and need to specify sections along the chord of the airfoil so I can apply geometry deformations to different areas. In simply terms I need to use the format for

X>(a certain section length) then one set of equations is valid
X<(a certain section length) then another set of equations is valid

where x is the chord length of the airfoil.

Any help would be greatly appreciated.

Regards

Kim
0 Replies Last Post 2011年7月13日 GMT-4 12:28
COMSOL Moderator

Hello Kim Smith

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content