Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Problems in Velocity profile (Laminar flow).

Please login with a confirmed email address before reporting spam

Hello everyone, I'm working on fluid dynamical model with considering Laminar flow and Heat transfer in fluid model physics. While setting the initial velocity = 0 [m/s] and initial pressure = 0 [atm] in Laminar flow model and considered Spherical heat source (with power 57 mW) in the Heat transfer in fluid. When I run the program, the temperature profile result generated but velocity profile shows null result as shown in below figure. But when I choose the initial pressure = 1 [atm] with initial velocity = 0 [m/s]. It generates the velocity profile of fluid flow shows results but velocity in the range of 10e-20 [m/s] which is too small. So anyone have proper reason for this please explain.



0 Replies Last Post 2018年10月21日 GMT-4 12:02
COMSOL Moderator

Hello Krishnkumar Gupta

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.