Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Solid melting and fluid flow

Please login with a confirmed email address before reporting spam

Dear, all

I am working with problem ;

(1) solid melting because of heat source Q

(2) navier stokes will be solved where liquid fraction is 1

But there was problem, velocity profile was appeared at liquid fraction was 0 (plz check attached image)

How can i set up the problem " Navier Stokes eq will be solved at liquid fraction is 1"?

Best regards.


1 Reply Last Post 2015年11月4日 GMT-5 20:12
COMSOL Moderator

Hello JiYoung Park

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.


Please login with a confirmed email address before reporting spam

Posted: 9 years ago 2015年11月4日 GMT-5 20:12
Hello,
Recently, I miss the same problem with you. Have you solved the problem? If you have, can you tell me how you do this.
Thank you very much!
Hello, Recently, I miss the same problem with you. Have you solved the problem? If you have, can you tell me how you do this. Thank you very much!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.