Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Pressure Drop Black Box
Posted 2018年12月17日 GMT-5 11:14 General, Computational Fluid Dynamics (CFD), Modeling Tools & Definitions Version 5.3a 0 Replies
Please login with a confirmed email address before reporting spam
I am modeling a facility exhaust system at a plant in order to properly balance the system with new additions we are planning. In this exhaust system we have a filter bank where there is a pressure drop that is gauged so we always know what the exact pressure drop is.
I am new to COMSOL and thought a good way to model this would be to use a poros material and adjust my permiability and porosity until I matched the pressure drop that is measured. I was wondering if anyone would know of a better way to add in a pressure drop between two interfaces thats easier than adjusting a filter material.
The actual physics of the filter is not important nor is any interactions happening in the filter bank. This model is simply to balance the system so any method to acheive that pressure drop is viable in the model.
Hello Jack Bauers
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.