Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Solution Convergence Error, Phase Change in Rotating Mould using Moving Mesh
Posted 2011年9月7日 GMT-4 06:47 Fluid & Heat, Heat Transfer & Phase Change, Mesh, Studies & Solvers 1 Reply
Please login with a confirmed email address before reporting spam
I am facing problem in modeling a rotating mold filled with polymer powder that is being heated continuously. However my solution is not converging. The solver error is "LAST TIME STEP DID NOT CONVERGE".
Kindly help me figure out the error. I tried changing parameter values but to no avail.
Please help.
-Raghav
Hello Raghav Bansal
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam