Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Meshing a specimen

Please login with a confirmed email address before reporting spam

Hello, I'm a student and I am trying to mesh a tensile test specimen.

The specimen that I am trying to mesh has a defect as if someone scooped an ice cream on the top surface of the specimen.

I provided an image below and I also attached the mph file.

Any help or hint to mesh this object would be greatly appreciated.

P.S. I know this is beyond the question but it would be really nice if someone can verify that the tensile test is done in a right way. I got my stress strain data table from outside source and put the data directly into Comsol using interpolation tab.

Best regards, JungWoo Choi



0 Replies Last Post 2019年10月11日 GMT-4 02:28
COMSOL Moderator

Hello JungWoo Choi

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.