Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
A question about not being able to converge
Posted 2019年10月28日 GMT-4 13:33 0 Replies
Please login with a confirmed email address before reporting spam
Dear all,
Attached is a COMSOL 5.3 model about making a nanogap between two gold electrodes on PDMS substrate, and stretch the PDMS substrate to see how nanogap distance changes accordingly.
It works for the applied strain ~ 2%, the nanogap distance is still 80% of the initial gap, which is 5 nm (as shown in the attached image), but with just a little bit higher strain such as 3 or 4%, it doesn't converge anymore no matter how I change the configuration.
Would like to ask for your kind advices to figure out why it doesn't converge at the certain point and/or what I can do to try to make it converged.
Thank you very much : )
Best Regards, Henry
Attachments:
Hello Henry S.C. Yu
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.