Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

FSI: Form Union vs Assembly

Please login with a confirmed email address before reporting spam

Hi,

I have an FSI problem with multiple elastic plates floating on the surface of a fluid. When FORM UNION is used, the model fails when there occur collision between plates. I have tried FORM ASSEMBLY, with "IDENTITY BOUNDARY PAIRS" at fluid-solid interface. But I cannot select the boundary to apply the multiphysics FLUID STRUCTURE INTERACTION.

Does this means that FORM ASSEMBLY can only be applied for FLUID STRUCTURE INTERACTION, PAIR ?

Thanks and regards, Dharma


1 Reply Last Post 2019年11月7日 GMT-5 06:47
Henrik Sönnerlind COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 2019年11月7日 GMT-5 06:47
Updated: 5 years ago 2019年11月7日 GMT-5 06:48

Hi Dharma,

That is correct. If it is an assembly you should use Fluid-Structure Interaction, Pair.

Regards,
Henrik

-------------------
Henrik Sönnerlind
COMSOL
Hi Dharma, That is correct. If it is an assembly you should use Fluid-Structure Interaction, Pair. Regards, Henrik

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.