Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Swept Mesh - Cylinders

Please login with a confirmed email address before reporting spam

Does anyone know how to add swept mesh to the outer surronding hollow cylinder as shown in the figure below. I have created a boundary trianglular mesh on the faces of the cylinders, but COMSOL only creates the mesh on the inside cylinder and gives the error "Unsupported topology of linking face" for the outside cylinder. Any help would be appreciated!

Cheers!

Moin

-------------------
Moin


0 Replies Last Post 2020年1月8日 GMT-5 23:51
COMSOL Moderator

Hello Moin

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.