Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Couple a 3D with a 1D model

Please login with a confirmed email address before reporting spam

Hello,

I would like to calculate the heat conduction in a metal plate, which is cooled with cooling water that flows through a borehole in the plate. The conduction in the plate should be modeled in 3D. For the cooling water only the temperature should be modeled in 1D (in flow direction) using heat transfer coefficients for the heat transfer from the plate to the water. How could this be done ?


1 Reply Last Post 2020年1月21日 GMT-5 09:36
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 2020年1月21日 GMT-5 09:36
Updated: 5 years ago 2020年1月21日 GMT-5 09:38

Hello Henrik,

If your license includes the Pipe Flow Module, you can follow the approach presented in this model. Without the Pipe Flow Module, you would need to use a component coupling to pass the information between the 2D boundary of the borehole in the 3D model and the 1D midline of the pipe. See also this similar thread.

Best regards,

Jeff

-------------------
Jeff Hiller
Hello Henrik, If your license includes the Pipe Flow Module, you can follow the approach presented in [this model](https://www.comsol.com/model/cooling-of-an-injection-mold-12371). Without the Pipe Flow Module, you would need to use a component coupling to pass the information between the 2D boundary of the borehole in the 3D model and the 1D midline of the pipe. See also this [similar thread](https://www.comsol.com/forum/thread/246201/cooling-down-a-barrel-of-wort?last=2019-11-14T13:42:40Z). Best regards, Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.